1960's G.E. Trimline 500 SS Stereo
Posted: Wed Nov 18, 2026 11:10 pm
Finished this up today for a customer who had brought it
by from 50 miles away !
The amplifier controls were very dirty and mostly non-functional.
To access the solid state amp, remove the chrome controls panel,
then the larger rear cover panel which sits in two clips.
Then there are 2 more screws to release the amplifier.
I was able to get enough cleaner into the 4 pots without
dis-connecting all the amp wiring.
Next, the changer needed basic cleaning of the motor
board speed controls, motor cleaning, new motor mounts,
record spindle thrust washers, platter bearing race,
and some cleaning of cycling mech.
The tonearm required set-down and end of record actuator adjustments.
The original idler wheel works well after cleaning.
,
,
by from 50 miles away !
The amplifier controls were very dirty and mostly non-functional.
To access the solid state amp, remove the chrome controls panel,
then the larger rear cover panel which sits in two clips.
Then there are 2 more screws to release the amplifier.
I was able to get enough cleaner into the 4 pots without
dis-connecting all the amp wiring.
Next, the changer needed basic cleaning of the motor
board speed controls, motor cleaning, new motor mounts,
record spindle thrust washers, platter bearing race,
and some cleaning of cycling mech.
The tonearm required set-down and end of record actuator adjustments.
The original idler wheel works well after cleaning.
,
,