Page 1 of 1

Record player parts are getting spendy....

Posted: Thu May 16, 2024 5:52 pm
by electra225
I'm going to have $150 hard money in each of the little GE Trimline stereos I inherited. Wow! This used to be a cheap hobby. Now I need about 7 drive tires for VM changers. Wonder if Gary gives a volume discount?...... ;) :oops: :roll:

Re: Record player parts are getting spendy....

Posted: Thu May 16, 2024 10:35 pm
by William
Yes, not cheap anymore. I need 4 or 5 drive tires myself.

Bill

Re: Record player parts are getting spendy....

Posted: Thu Jun 06, 2024 12:51 am
by TC Chris
Have you tried the O-ring option? It worked well on my Lenco, but that originally had a triangular section tire, so the smaller contact area was not an issue. Can't beat the price. And for wider tires, since they're cheap, maybe try two or three O-rings, side by side?

Chris Campbell

Re: Record player parts are getting spendy....

Posted: Thu Jun 06, 2024 1:41 am
by electra225
I haven't. I might try that on one I have to see what would happen. Gary wants $38 each for drive tires, plus shipping both ways. I need seven, along with seven sets of motor mounts. Do the math. ;) :oops:

Re: Record player parts are getting spendy....

Posted: Thu Jun 06, 2024 3:23 am
by TC Chris
I'd try it--the cost of the experiment is not prohibitive. You could try one large-section I-ring and then try several small-section ones to see which works best. My theory is that you don't want them to stretch much since they are not intended to be rubber bands.

Chris Campbell

Re: Record player parts are getting spendy....

Posted: Thu Jun 06, 2024 3:55 pm
by electra225
The issue I see with that is getting the amount of rubber outside the metal wheel needs to be pretty close to right or it might cause interference in the speed control mechanism. I'd like to try doing one for grins, but my luck is not good enough to get by with it on a "scale" basis, doing several of them at once.