Old motor
Posted: Fri Jan 19, 2024 3:51 am
I've got an old electric motor, labeled "Electrolux Corp." It's clearly not a vacuum cleaner motor because it has a cast and machined case. I'm guessing that it was a contract product for somebody else. It has two sets of numbers stamped (twice) on the case. 645257 and 263107. There is a Cornell-Dubilier capacitor case on the outside, stamped "VC-1835" and "3 x .03 mfd." and "3 x 3 ohms." It's also stamped "115 VAC." So the box seems to have 3 caps and 3 small resistors inside.
The motor uses a commutator and brushes. It has ball bearings. It also has a set of multiple terminal screws and a movable jumper wire. I'm a bit puzzled by where it came from and how to hook up power on the terminals. Maybe we have somebody with the special esoteric knowledge to ID this device?
Chris Campbell
P.S. I just plugged the cap. part no. into Google and it showed me almost the same motor. Mine is lacking the end cap opposite the shaft and the second part no. is slightly different. View here:
https://www.ebay.com/itm/194209228989
The motor uses a commutator and brushes. It has ball bearings. It also has a set of multiple terminal screws and a movable jumper wire. I'm a bit puzzled by where it came from and how to hook up power on the terminals. Maybe we have somebody with the special esoteric knowledge to ID this device?
Chris Campbell
P.S. I just plugged the cap. part no. into Google and it showed me almost the same motor. Mine is lacking the end cap opposite the shaft and the second part no. is slightly different. View here:
https://www.ebay.com/itm/194209228989